How to use LED tape?

How to use LED tape?

Use conductive Addressable Rgb Led tape to connect the positive and negative poles of the light-emitting diode with the positive and negative poles of the battery, and then connect the tact switch to complete a simple closed circuit. Press the switch and the Dining Room Led Strip Light will light up.

Connect the battery (P1), Led Strip Light with Plugled Strips (D1), and switch (S1) to the circuit according to the schematic diagram. Note that the long leg of the LED light is positive, that is, corresponding to the "+" position, and the short foot is negative, corresponding to the "-" position. When the switch (S1) is pressed, the circuit conducts to form a loop and the LED light will be lit.

Circuit schematic note: When the Addressable Rgb Led tape is reversed, the Dining Room Led Strip Light will be in a high resistance state, which is equivalent to a large resistance in the circuit, even if the switch Led Strip Light with Plugled Strips is pressed, it will not emit light. In addition to judging the positive and negative polarity of the Led Strip Light with Plugled Strips through the long and short feet, you can also observe the inside of the Dining Room Led Strip Light, the pin of the large connection of the bracket is negative, and the connection pin of the small bracket is positive.